Ask us - button

Vaporizer System for Glass Surface Treatment


The application of paint or labels to surfaces can be trickier than one would expect. Just as in applying paint to a wall in one’s home, if the surface is not properly prepared the result will be less than perfect. A leading manufacturer of glass coating equipment was looking for a way to improve their coating process and increase their competitive advantage.

The process involves driving HMDSO vapour through a flame for surface treatment of glass. The end result is obtaining a hard SiOx-like thin film leading to a more wettable surface prior to painting or labeling. Initially the customer had tried using a syphon tube in the liquid HMDSO source that sucked up liquid into the fuel stream and into the burner. This was unsuccessful as it resulted in a very unreliable liquid flow because liquid draw was based on gas velocity. Next, the customer tried using a bubbler system. With the bubbler the customer found that the vaporization changed with bubbler liquid depth, delta P, temperature, and other un-controllable factors. Also, neither of these two processes provided recordable data feedback, so variations in surface treatment could only be detected at final product QC.

The Bronkhorst® solution was to provide a
system where the HMDSO vapour added to
the flame could be accurately and precisely
controlled. This was done through using a
mini CORI-FLOW for the control of HMDSO
liquid, an EL-FLOW Select thermal mass
flow controller for the carrier gas, a
Controlled Evaporator Mixer (CEM) to
completely vaporize the HMDSO, and an E-
8000 readout/control unit
to power and
control the vaporizer system.
Since implementing the Bronkhorst® CEM
this customer has reduced the cost
of materials as they are using precisely
what is needed in the process, improved
product quality as any variations can be
seen and adjusted early in the process, and
now has archived data for documentation
and review.


Diese Seite teilen: